ACR Electronics RCL-75 Product Support Manual page 13

6) At the point where the grey bulb wire passes through the
partition wall, remove the sealant with a razor, screwdriver or snips.
Beneath the sealant is a wire sleeve. Hold this sleeve with needle
nose pliers and push through the partition wall (see Figure 12).
7) Gently remove the entire reflector assembly from the body (see
Figure 13).
Figure 12
8) Place the reflector assembly face down.
9) Remove rubber sleeve (see Figure 14).
10) Squeeze the 2 wire ends of the G-clip together to release the
insert pin from the reflector and remove the clip (see Figure 15).
11) Pull bulb out and discard.
Figure 14
Y1-03-0158H
Figure 13
Figure 15
12