Use Of Remote Control - Mitsubishi Electric P93W Operation Manual

Use of Remote Control

Connect the wired remote control to
the remote control terminal on the
rear panel.
Press the button on the remote
control to print pictures.
This button functions the same as the
PRINT button.
When no signal is input, the button is
invalid.
Precautions on Printing
When dark pictures are printed consecutively, the Video Copy Processor may become
overheated and the indicator blinks.
In this case, wait for a while until the unit is cooled down.
Avoid pulling out or holding the paper during printing or copying to prevent paper jam.
Do not touch the paper until printing or copying finishes.
When printing is carried out with no signal input, "NO SIGNAL" will be printed at the bottom
of the print.
Paper saving mode
When the paper saving mode (SAVING : ) is selected to " " by FUNC button, the amount of
paper fed is smaller than in normal paper feeding.
Press and hold the FEED button on the front panel to feed the paper to cut the paper at
the appropriate position.
Rear panel
ON
OFF
DIP SW
IN OUT
AC LINE
VIDEO
DIP SW FUNCTION TABLE
NO. 1 2 3 4 5 6
FUNCTION IMP TRAP MEMORY RESERVED
SW-ON 75 ON FIELD
SW-OFF HIGH OFF FRAME
13
REMOTE
To remote control terminal