Appendix D - User Interface: Digital Display During Self-Test - ACR Electronics GLOBALFIX iPRO RLB-36 Product Support Manual

APPENDIX D - USER INTERFACE: DIGITAL DISPLAY
DURING SELF-TEST
The following chart describes the display and audio-visual feedback the
beacon provides during Self-Test. The messages on the digital display
typically appear as one or two words at a time, until the entire message has
been displayed.
GlobalFix™ iPRO Display, LED/ Audio Signaling and Description of Operation
Beacon Self-Test has been initiated, and the ACR Electronics' Welcome Page appears.
Next, the product name page appears.
BATT >
The first test checks the available hours of battery life (battery witness seal). If remaining
battery life is greater than 48 hours at -20° C, the test passes.
BATT >
The first test checks the available hours of battery life (battery witness seal). If remaining
battery life is less than 48 hours at -20° C, the test fails.
MEM √
(EEPROM memory). If no errors are present the test passes.
MEM 
The second test checks the beacon message for absence of errors (EEPROM memory). If
an error(s) is present, the test fails.
BOARD
functionality. If the board is performing properly, the board passes.
BOARD
The third test checks circuit board (lock circuit) functionality. If the board is not performing
properly, the board fails.
Y1-03-0233 Rev. F
48HR √
48HR 
beep
G
The second test checks the beacon message for absence of errors
beep beep
R
√
TEST
The third test checks circuit board (lock circuit)
TEST 
beep
G
beep beep
R
beep
G
beep beep
R
33