4G9 Engine (E - Mitsubishi 4G9 series Manual

MD998716
Set hole (A)
E
Mitsubishi Motors Corporation
4G9 ENGINE (E - W) -
(6) Slightly loosen the tensioner pulley fixing bolt which is
(7) Turn the crankshaft clockwise by two turns.
(8) Check that the timing marks are aligned.
(9) Tighten the fixing bolt of the tensioner pulley.
"EA AUTO-TENSIONER INSTALLATION
(1) If the auto-tensioner rod is fully extended, set it in the
Set hole (B)
(2) Install the auto-tensioner
Nov. 1995
Timing Belt
tightened temporarily to tighten the belt by a force of
the tensioner spring.
retracted position with the following procedure.
1) Hold the auto-tensioner in a vice, being careful not
to tilt it.
2) Slowly close the vice to force the rod in to align hole
(A) of the rod with the set hole (B).
3) Insert a 2.0-mm-Allen key in diameter or similar into
the set holes.
4) Remove the auto-tensioner from the vice.
Leave the align key until installation of the timing belt
is completed.
PWEE9502-A
11A-4-5
Revised