Mitsubishi 4G9 series Manual page 126

11A-12-4
4G9 ENGINE (E - W)
Paint marks
90_ - 100_
E
Mitsubishi Motors Corporation
-
Crankshaft, Cylinder Block, Flywheel and Drive Plate
(5) Make a paint mark on the head of each bolt.
Paint
(6) Make a paint mark on the area around the bolt bearing
marks
(7) Give a 90_ to 100_ turn to the bolts in the tightening
(8) After installing the bearing caps, make sure that the
"DA OIL SEAL INSTALLATION
MB990938
MD998776
"EA SEALANT APPLICATION TO OIL SEAL CASE
Nov. 1995
surface at location 90_ to 100_ in the direction of tightening
the bolt, as referenced from the paint mark on the bolt
head.
sequence. Make sure that the paint mark on the bolt
and that on the area around the bolt bearing surface
are in alignment.
Caution
1. If the nut is turned less than 90_, proper fastening
performance may not be expected.
tightening the nut, therefore, be careful to give
a sufficient turn to it.
2. If the nut is overtightened (exceeding 100_), loosen
the nut completely and then retighten it by
repeating the tightening procedure from step (1).
crankshaft turns smoothly and the end play is correct.
If the end play exceeds the limit, replace crankshaft
bearings.
Standard value: 0.05 - 0.25 mm
Limit: 0.4 mm
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
PWEE9502-A
When
Revised