Mitsubishi Electric DLP WD8200U User Manual page 29

Viewing video images (continued)
D. Projecting images
Preparation:
LAMP 2 indicator
POWER indicator
LAMP 1 indicator
Main power switch
1. Put the projector into standby mode by pressing the main power switch. The POWER indicator lights up red.
and the POWER button may not work after the main power switch is turned ON. (The LAMP indicator blinks
green.) After the fan stops rotating, press the POWER button to turn back on the POWER indicator.
2. Turn on the power of the connected video equipment.
3. Press the POWER button.
lens cap.
product malfunction.
in the menu is activated. During the activation, displayed images may be disturbed.
may appear dark and no commands are accepted.
the LAMP indicator blinks red. (See page 71.)
4. Press the ZOOM/FOCUS button to display the ZOOM/FOCUS menu.
5. Adjust with the or
switched between FAST and STEP. When FAST is selected, the speed of focus controlled by the
becomes fast, and it becomes slow when STEP is selected.
6. Select an input source.
that is corresponding to the terminal in use.
the projector.
signal, such symptom is not a malfunction.
IN (HDCP) terminal, press the COMPUTER/DVI-D button on the projector to select DVI or press the DVI-D
(HDCP) button on the remote control.
COMPUTER/COMPONENT VIDEO IN-2 terminal, press the COMPUTER/DVI-D button on the projector or the
COMPUTER 1 or COMPUTER 2 button on the remote control.
POWER button
, , , buttons
COMPUTER/DVI-D button
ENTER button
ZOOM/FOCUS button
LENS SHIFT button
button to get a fine picture.
COMPUTER 1, 2 buttons
VIDEO/HDMI button
LENS SHIFT button
ZOOM/FOCUS button
EN-29
POWER button
HDMI button
VIDEO button
S-VIDEO button
DVI-D(HDCP) button
ENTER button
, , ,
buttons
or button