Mitsubishi Electric DLP WD8200U User Manual page 15

Setting up your projector (continued)
performed, the displayed image may be distorted.
projector and the screen, a perfect rectangular
image and the proper aspect ratio may not be
obtained. Slight distortion can be corrected by the
CORNERSTONE-mode adjustment.
KEYSTONE-mode adjustment because of the type
of the video signal being projected and the setting
values of the KEYSTONE-mode adjustment. In
such cases, set the KEYSTONE-mode adjustment
values in the range where the image is displayed
without noise.
adjustment and the CURVED-mode adjustment
in combination, the adjustment range becomes
narrower than that in the case where you carry out
these adjustments individually. When setting the
KEYSTONE-mode adjustment value to 11 or larger,
you cannot use the CURVED-mode adjustment.
adjustment while the option lens is in use, you
may not be able to obtain a perfectly rectangular
image or the correct aspect ratio. Slight distortion
can be corrected by the CORNERSTONE-mode
adjustment.
Adjustment using the CORNERSTONE mode:
Use this adjustment for fine adjustment of the image
shape. You can use this adjustment for adjusting
the image displayed in the edge blending mode
(see page 36), too. For adjustment, press the
ENTER/GEOMETRY button on the projector or the
GEOMETRY button on the remote control to display
the CORNERSTONE mode and then press the
or button.
CORNERSTONE
Every time you press the BLANK button, the
adjustment menu changes as follows:
LOWER RIGHT → LOWER LEFT → UPPER RIGHT →
UPPER LEFT → RESET → LOWER RIGHT ...
: 0
: 0
LOWER RIGHT
SELECT : BLANK
LOWER RIGHT, LOWER LEFT, UPPER RIGHT, or
UPPER LEFT menu
You can adjust the horizontal or vertical position of the
selected corner.
Example: Adjustment of the upper left corner position
Press the
button.
When you press the
mode, the distortion correction is reset.
Important:
effect, the resolution decreases. In addition, stripes
may appear or straight lines may bend in images
with complicated patterns. They are not due to
product malfunctions.
performed, the displayed image may be distorted.
CORNERSTONE-mode adjustment because
of the type of the video signal being projected
and the setting values of the CORNERSTONE-
mode adjustment. In such cases, set the
CORNERSTONE-mode adjustment values in the
range where the image is displayed without noise.
, ,
may not be corrected by the CORNERSTONE
-mode adjustment.
EN-15
(UPPER LEFT)
Press the
button.
Press the
button.
or button in the RESET
Press the
button.