Mitsubishi Electric DLP WD8200U User Manual page 22

Viewing computer images (continued)
D. Projecting images
Preparation:
LAMP 2 indicator
POWER indicator
LAMP 1 indicator
Main power switch
1. Put the projector into standby mode by pressing the main power switch. The POWER indicator lights up red.
and the POWER button may not work after the main power switch is turned ON. (The LAMP indicator blinks
green.) After the fan stops rotating, press the POWER button to turn back on the POWER indicator.
2. Turn on the power of the connected computer.
3. Press the POWER button.
lens cap.
product malfunction.
in the menu is activated. During the activation, displayed images may be disturbed.
may appear dark and no commands are accepted.
the LAMP indicator blinks red. (See page 71.)
4. Press the ZOOM/FOCUS button to display the ZOOM/FOCUS menu.
5. Adjust with the or
switched between FAST and STEP. When FAST is selected, the speed of focus controlled by the
becomes fast, and it becomes slow when STEP is selected.
6. Select an input source.
button on the remote control that is corresponding to the terminal in use.
DVI-D button on the projector.
the screen.
signal, such symptom is not a malfunction.
press the AUTO POSITION button. (See page 24.)
flicker. Press the
7. Adjust the position of the projector to keep an appropriate projection distance with which images are projected in
their specified sizes.
8. Adjust the position of the projector so that the projector and the screen are perpendicular to each other. (See page 11.)
When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See page 14.)
POWER button
, , , buttons
COMPUTER/DVI-D button
ENTER button
ZOOM/FOCUS button
LENS SHIFT button
button to get a fine picture.
or button on the remote control to reduce flicker, if it occurs. (Fine adjustment)
COMPUTER 1, 2 buttons
,
LENS SHIFT button
ZOOM/FOCUS button
EN-22
POWER button
, , buttons
DVI-D(HDCP)
button
ENTER button
or button