Table of Contents
Advertisement
Installation Procedure
Before you start...
If you are installing PAM to run over a network, determine the computers
and servers onto which you will install PAM. Obtain the IP addresses of all
RAID PCs where PAM will be installed.
UltraTrak Users
The UltraTrak is an external enclosure and must be online during PAM
installation. Follow these steps before you install PAM:
1. With your UltraTrak powered down, attach a null modem cable to the
UltraTrak serial port connector and one of the COM ports on your RAID
PC.
PAM will automatically detect the UltraTrak during installation.
2. Power up the UltraTrak and wait for it to boot completely.
3. Proceed with the PAM installation.
PC with FastTrak card
PAM Installation
With that information ready, follow these steps to install PAM on each
computer or server:
1. Boot the PC/server and launch Windows.
If the computer is already running, exit all programs.
2. Within Windows, go to Start > Run.
PC with SuperTrak card,
Internal RAID array
Figure 2-2. Three examples of RAID PCs.
11
Installation
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
PC with UltraTrak
RAID Subsystem
Advertisement
Table of Contents
