Using The T-Loop; Making And Receiving Calls - Geemarc t-LOOP Instruction Manual

USING THE GEEMARC t-LOOP

Making and Receiving Calls

Place the wire around your neck. Insert the round connector plug
into the Neckloop Quick Disconnect plug; this forms a loop around
your neck. Ensure you have double clicked the connection.
Connect the 2.5mm plug of the Geemarc t-LOOP into the telephone's
2.5 mm headset jack
Switch your hearing aid to T (or MT) mode.
Press the ON/OFF button; you are ready to speak through your
Geemarc t-LOOP. The green light will turn on.
Make and receive calls as normal (refer to telephone user guide)
The volume of the Geemarc t-LOOP can be adjusted by using the
volume control knob found on the bottom of the Geemarc t-LOOP.
This gives up to 30 dB gain.
Press the ON/OFF button when the call is finished. The green light will turn off.
Reset your hearing aid if necessary.
Do not forget to turn OFF your Geemarc t-LOOP at the end of
the call. Failure to do this will drain the batteries after about 30
hours.
Note: The Geemarc t-LOOP has a built in microphone hence you
do not need to hold the telephone to your ear. Instead, you can use
it with a belt clip or place it on a flat surface such as a table.
If your telephone does not have a 2.5mm jack, you may need an
adapter. Check with the telephone manufacturer.
6