Honda HF2315HME User Manual page 47

EN 46
out loosening or changing the position of the nuts (8) and locknuts (9).
Remove the two cotter pins (10) of the rear pins.
After checking that there are no obstructions, remove the deck in such a way
that all the pins come out of their housings.
When assembling, ensure that the two rear holes of the corner joints are used
for fixing the pins (7). Perform the operations described above in reverse while
making sure that the front terminal of the collector channel properly fits onto
the exit of the cutting deck.
b) Dismantling, sharpening and balancing blades
WARNING!
!
balancing, remounting and/or replacing) require a certain familiarity and
special tools. For safety reasons, go to a specialized centre if you do not
have the right tools or experience.
WARNING!
!
gloves when handling the blades.
To remove a blade, hold it firmly and
undo the central bolt (1) (use 15 mm
wrench) in the direction indicated by
the arrow for each blade, noting
that one of the fixing bolts has a
right-hand thread and the other one
has a left-hand thread.
Sharpen the two cutting edges using a
medium grade grinding wheel and check
the balance by holding the blade up with a
screw driver inserted in the central hole.
WARNING!
!
blades must always be replaced;
never try to repair them! ALWAYS USE
MANUFACTURER'S GENUINE
BLADES!
All operations on the blades (dismantling, sharpening,
Wear heavy
Damaged or bent
MAINTENANCE
1
1