Sharp PC-A820 Manual page 74

Password Requirements
If you have enabled Password on boot in the Security page of the setup utility, the
system will ask for a password when the system is started. If a user password is
entered, then the user has limited access to the floppy disk drive as set by holder of
the supervisor password.
When the setup utility is opened, a password is required. If a user password is
entered, the user does not get access to the Advanced page of the setup utility. On the
Security page of the setup utility, the user cannot get access to the Set Supervisor
Password, the Password on boot, or the Diskette access items.
Setting a Password for Standby/suspend Resume
Use the Windows Power Management Properties program to set a password that
must be entered in order to resume the system from a standby/suspend-to-RAM
mode. If you have already installed a Windows password you can skip steps 1-4.
1. From the Start menu, select Settings - Control Panel.
2. In the Control Panel, click on the Passwords icon to open the Passwords
Properties windows.
Use the Change Passwords tab to install a password for windows.
3.
4. You need to restart your computer to complete the password installation.
5. Return to the Control Panel. Double-click the Power Management icon to open
the Power Management Properties window.
6. Click on the Advanced tab. Check the box marked Prompt for password when
computer goes off standby.
7
7-3