Table of Contents
Advertisement
Changing a Battery Pack
The procedure to remove and install a battery pack is as follows:
1.
Turn off the computer, close the upper cover and turn the computer over and lay
on a soft surface.
2.
On the left side of the computer, locate the battery lock button.
3.
On the base of the computer, locate the pressure point embossed on the base of
the battery pack for pushing it out of the battery compartment.
4.
Press and hold down the battery lock button and push on the raise ribs to slide
out the battery pack.
5.
You can release the battery lock button once the battery pack is partially
removed.
6.
After the battery pack is completely removed, hold the replacement battery in a
horizontal position level with the battery compartment and slide it into place.
Guide rails on either side of the compartment, and grooves on the battery pack
guide the battery pack into place.
7.
Push the battery all the way in so that you feel the battery pack engage with the
connector inside the compartment and the battery lock in place.
Raised ribs to push
battery pack
Battery pack
Battery lock button
3 3
3-5
Advertisement
Table of Contents
