Table of Contents
Advertisement
Communication Functions
This chapter explains how to use infrared communications and the built-in modem.
Infrared Communication
Using the IR (infrared) port located on the right side of your computer, you can
communicate wirelessly with infrared-equipped devices such as electronic
organizers, computers or printers. To establish infrared communication, follow the
instructions below. See the manual or online help of each application for details.
Positioning and Preparing the Computer and the Target Device
1.
Put your computer on a flat surface.
2.
Place the target device so that its IR port is in line with that of your computer.
3.
Adjust the distance between the IR ports to be less than 20 inches (50 cm).
When using a Sharp electronic organizer, make sure the two IR ports are
within 12 inches (30.5cm).
Setting for Infrared Communication
1.
In the Advanced menu of the Setup Utility, make sure the IR Mode is IrDA.
2.
Disable System standby in Window 98. Refer to Disabling Power Management
in Chapter 3.
3.
In the Infrared Monitor dialog box in the Control Panel, select Options and
enable infrared communication.
During infrared communication:
Do not move the computer and the other IR device.
Do not enter System standby.
Do not use a cellular phone or another IR device near the computer.
CHAPTER 5
5-1
5
Advertisement
Table of Contents
