Table of Contents
Advertisement
LAN unit
Your computer is equipped with a 100 Base-TX/10 Base-T LAN interface. To
activate the LAN adapter, perform the following steps.
1.
Turn off the computer.
2.
Connect one end of the LAN cable into the LAN jack on the rear side of the
computer.
3.
Connect the other end of the LAN cable into the network hub.
LAN Jack
4.
Turn on the notebook.
When Press <F2> to enter SETUP appears, press F2.
5.
6.
In the Advanced menu, enable LAN.
7.
Press Esc; then Enter twice. The system restarts.
8.
In the Network dialog box, set fields according to your network status. Refer to
your network administrator.
You cannot use the LAN unit when your notebook is in MS-DOS mode.
You cannot use the LAN unit when you connect an optional external
battery(CE-BL03).
If you cannot access the network,
1.
From the Start menu, select Settings – Control Panel.
2.
Double-click the Network icon.
3.
In the Network dialog box, select Configuration tab.
4.
Click Realtek RTL8139 xxxxxx; then Properties.
5.
Click Advanced tab, and select Link Speed/Duplex Mode in Property: and enter
an appropriate value in Value:.
6.
Click OK twice and restart your computer.
To Network
5
5-5
Advertisement
Table of Contents
