Table of Contents
Advertisement
UNPACKING THE UNIT
/COVER
FLAVOR GENERATOR
INSERT
Remove
all
packing
material
from
unit
and
any
accessories.
Grill/Griddle
Models - Assemble grill/griddle
as shown in
Figure 4. Set aside.
Be sure to remove the pressure regulator and all hard-
ware before disposing
of carton.
When raising or lowering the cooktop itself use the front
two burner openings.
KGCG260S,
GSUG-360
Figure 4
INSTALLING IN CABINET
Prior to installation
test the electrical
service to assure that it agrees with the electrical
specifications
given in
this booklet for your model.
Study all tags and labels and follow their instructions
during installation.
Place cooktop in countertop
cutout. Center and align unit in opening making sure that required clearances
are
maintained.
Remove rear burners & venturi before installing
unit.
Determine which of the following
two mounting
methods, shown in Figures A and B (top of next page), is to be
used. When using either method be sure to use the outermost
applicable
mounting
hole.
NOTE: With some installations,
i.e. replacements,
it is possible that both methods may be used.
Hardware for both methods is provided and consists of 4 - wood screws and 4 - bolt and clamp assemblies.
WOOD SCREW AND WASHER ASSEMBLY
Figure A
When possible the burner box may be fastened directly to the countertop using a wood screw and washer assembly.
Using the cup washer from the bolt and clamp assembly place wood screw provided through washer.
1. Each unit has double action hinges which allow the front and. back mounting holes to be exposed individually.
After centering and aligning unit in cutout, lift cooktop by placing a hand in each front burner opening and hold
in place with support rod. See Position 1. Secure burner box using wood screw and washer assembly in front
two outermost
mounting
holes. As shown in Figure A.
IMPORTANT
NOTE: Due to flange design hand tighten only until outer lip is snug to countertop.
Overtightening
may stress flange and cause crazing and chipping
of porcelain.
SUPPORT ROD
COUNTERTOP
I
L
BURNER BOX
/
COOKTOP
FWtlOfl1
-2
2. To expose back mounting
holes, lift cooktop slightly, disengage
support rod and pull cooktop forward, without
lowering
it, until hinges lock. Lower cooktop until it rests on countertop.
See Position 2. Secure burner box
using back two outermost
mounting
holes.
3. After fastening
lift cooktop slightly and push back. Lower cooktop into normal position.
Advertisement
Table of Contents
