Electrical Connection - Maytag KGSC100S Installation Instructions Manual

30/36" built-in cooktops
Table of Contents

Advertisement

The burner box is 3% II deep. Additional
clearance
is required under the back 6" of the burner box for fuel and
power connections.
See Figure 5. The minimal clearances
between the cooktop and adjacent vertical combusti-
ble surfaces is 3 II on either side and 1 II in the back. See Figures 1 A and 1 B. Use Figure 2, below, for new
inStah
tions or use Figure 3 below for replacement
installations.
FOR NEW INSTALLATIONS
ONLY
FOR REPLACEMENT
INSTALLATIONS
ONLY
Note: When the cutout
illustration,
given below, is
followed the minimal side and back clearances
to ad-
jacent vertical combustible
surfaces will be met.
f
COUNTERTOP
CUTOUT
DIMENSIONS
FOR
NEW INSTALLATIONS
30" MODELS
36 " MODELS
Width
27 "
33% "
"B"
Dim.
47/ '1
4'/2 "
I
Figure 2
Note: In order to comply with AGA safety standards the
minimal side and back clearances to adjacent vertical
combustible
surfaces of 3 II and 1 II must be met when
installing
this unit. See Figures 1A and 16.
CWNTERTOP
L
4 CORNERS
DEPTH
BASE
CABINET
CUTOUT
DIMENSIONS
FOR
REPLACEMENT
INSTALLATIONS
Width
Depth
30" MODELS
36" MODELS
Minimum
Maximum
Minimum
Maximum
26% "
295/ "
33 "
347/' "
18% "
205/, "
16% "
205/ "
Figure 3
ELECTRICAL CONNECTION
WARNING:
THIS COOKTOP
IS PROVIDED
WITH A POLARIZED
THREE PRONG PLUG. IT IS NECESSARY
THAT THE OUTLET TO WHICH THIS PLUG IS CONNECTED
BE PROPERLY
POLARIZED
AND GROUNDED.
IF THE RECEPTACLE
IS NOT THE PROPER GROUNDING
TYPE, A QUALIFIED
ELECTRICIAN
SHOULD BE
CONTACTED.
This unit requires a polarized three wire grounded receptacle connected
to a 120 VAC, single phase, 60 hertz. See chart below for overcurrent
protection circuit size for your model. The receptacle must be installed
below the cooktop so that the service cord supplied with the unit may
be easily removed for servicing or cleaning the cooktop. (See Figure 5
under "Connecting
Unit to Gas" for locations.) This unit must be elec-
trically grounded
in accordance
with local codes, or in their absence,
with the National Electrical
Code, ANSI/ NFPA No. 70-1987.
Recommended
Method
PLUG WITH GROUND
PRONG
PROPERLY
POLARIZED
AND
GROUNDED
RECEPTACLE
KGCSl OOS, GSU-300
KGCS16OS, GSU-360
KGCG260S,
GSUG-360
OVERCURRENT
PROTECTION
15 OR 20 AMPERES
20 AMPERES
CIRCUIT SIZE
*-

Advertisement

Table of Contents
loading

Table of Contents