Amana Gas Range Installation Instructions Manual page 3

Place range near final position and
plug in. A 3-wire electrical cord
approximately 4 feet in length is
supplied on range. Then, slide range
into final position and adjust all legs
(4) until range is level side to side
and front to back.
• Place a level on top oven rack or
on range top when leveling.
• Leveling legs must extend ¼ inch
to engage anti-tip bracket.
1. Unplug range cord.
2. Turn off gas valve and disconnect gas supply.
3. Remove range and place aside.
4. Remove anti-tip bracket.
5. Install anti-tip bracket into new location using instructions provided
with bracket.
6. To reinstall range, follow instructions in this manual.
• Do not reuse a flexible connector after moving appliance.
After range is in position, remove storage drawer or lower panel and
confirm anti-tip bracket is engaged with range leveling leg.
To remove storage drawer
1. Slide drawer out until it stops.
2. Grasp drawer sides near back of drawer.
3. Lift up and out. Reverse to reinstall.
• Refer to Owner's Manual for
instructions on proper flame
adjustment.
• Failing to adjust flames properly
can result in poor cooking or
flaming.
To avoid risk of
damaging oven
door, do not lift or
move range by
oven door handle.
Glass can break.