Advertisement
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
Wrap a shop towel around the top of a flat-tip
screwdriver and insert it into the grooves of the
audio panel. Pull the audio panel out toward you to
release the five clips and remove the audio panel.
Take care not to damage the clips and the audio
panel. Disconnect the antenna lead and the 20-pin
connector from the rear of the cover.
CLIPS (5)
COVER
AUDIO
PANEL
FLAT-TIP
SCREWDRIVER
2.
Remove and discard the cover from the audio
panel (four tabs).
RETAINING
TAB
AUDIO
PANEL
2 of 3
VEHICLE 20-PIN
CONNECTOR
ANTENNA
LEAD
GROOVES IN
AUDIO PANEL
2828202K
COVER
(Not reused.)
RETAINING
TAB
2018030K
3.
Push the front of the pocket from above and below
and hold for one minute to fix the shape.
4.
Position the audio unit on the pocket and install
the two brackets with the four 5 x 8 mm washer-
bolts and two 4 x 12 mm self-tapping screws.
5 x 8 mm
WASHER-
SCREW
BRACKET
"L"
4 x 12 mm
SELF-
TAPPING
SCREW
Use the
upper hole.
Insert the
boss on the
pocket with
this hole.
AII 24298 (0212)
PUSHDOWN
POCKET
PUSHUP
2008060K
5 x 8 mm
BRACKET
WASHER-
"R"
SCREW
Use the
AUDIO
lower
UNIT
hole
4 x 12 mm
SELF-
TAPPING
SCREW
POCKET
Tighten with a screw
while pushing the
front of the pocket in
upward direction.
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
2625021K
Advertisement
