Table of Contents
Advertisement
Before Multiswitch Configuration Installation Procedure
Once the antenna has been mounted according to the previous instructions, you
can continue with the installation of the Combiner and Splitter:
1.
Be sure that the satellite TV receiver/tuner is plugged into an AC outlet.
2.
Take the RG-6 cable which you purchased to connect to the SIRIUS anten-
na and thread one end of the cable through the opening in the end of the
rubber boot. Then connect the cable to the antenna pod as shown in the
illustration following. Slide the rubber boot over the cable connection to pro-
vide a weather proof seal and install the cable tie around the cable directly
below the rubber boot to prevent the rubber boot from slipping down. Trim
off the excess cable tie. Route the remainder of the antenna cable to where
you are locating the Combiner. When routing the antenna cable, be careful
not to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture
the external jacket of the antenna cable.
3.
Connect one of the RG-6 cables you purchased from the SIRIUS antenna
to the SIRIUS RaDIo port on the Combiner (SR2261) as shown. (Refer to
page 5 for the Combiner port identification.)
Step 2
Step 3
Combiner
Home Signal Distribution Kit Installation Guide
Step 5
Step 4
EXISTING
RG-6 CABLE
C
EXISTING
M
RG-6 CABLE
Multiswitch
Advertisement
Table of Contents
