Table of Contents
Advertisement
Slide one of the U-bolts through the holes at the top of the mounting bracket.
Then slide one of the mounting brackets over the two legs of the U-bolt.
Next, screw the hex nuts on each leg until they are snug. Do not yet tighten the
hex nuts beyond finger tight. Repeat this procedure with the other U-bolt. When
all the hex nuts are snug, verify that the antenna is facing the correct direction
and begin tightening each hex nut with a 3/8" wrench. Turn each hex nut one-half
turn and then move to the next hex nut repeating this one-half turn pattern until
all the hex nuts are equally tight. Tighten the hex nuts enough so that the anten-
na is secured to the mast or pole, but do not overtighten them.
Adjusting and Aiming the Antenna
The pod portion of the antenna (where the SIRIUS logo is printed) needs to be
adjusted and aimed so that it is level and horizontal to the sky. There are two
possible adjustments that may be made on the antenna to accomplish this: tilting
the antenna pod itself (1), and adjusting the antenna support arm (2), as shown.
Home Signal Distribution Kit Installation Guide
5
Advertisement
Table of Contents
