Amana ARR6102 Series Owner's Manual page 14

OFF
OVEN BROIL WM
PREHEATED 550" /
_ 350
500 / 450 / 400
Oven Control
TIMER Pad Selects timer feature. Timer can be set up to 11 hour 59 seconds. Timer does not control
oven operation.
TIMER pad has light that flashes when timer is being set and glows when timer is counting
down.
CLOCK Pad Press to set clock and turn clock display on and off.
HRS Pads Increases or decrease time by hours.
MIN Pads Increase or decrease time by minutes.
OVEN Light Glows when oven is on. Light flashes after self-clean cycle turns off as a reminder to turn
temperature knob to OFF.
LOCKED Light Glows when oven door is locked and oven is set for self-cleaning. After self-clean cycle,
light flashes. Unlatch oven door and turn temperature knob to OFF.
PREHEATED Glows when oven reaches selected temperature.
Light
Temperature Controls oven temperature, self-clean, and broil. Push-to-turn knob prevents accidentally
Knob turning oven on.
Time Display Shows the time-of-day and timer minutes.
Timer light allows the user to identify timer mode quickly and easily.
Other Features
12-hour automatic
cancel
Service codes and
tones
As a safety feature, oven control automatically shuts off oven after 12 hours of operation.
This feature can be turned on or off.
To allow the oven to operate for more than 12 hours, confirm temperature knob is in OFF
position. Then, press and hold the MINS + and - pads for approximately
4 seconds. Display will change from time-of-day, show "OFF", and then return to time-of-
day.
To set oven to shut off after 12 hours, confirm temperature knob is in the OFF position.
Then, press and hold the MINS + and - pads for approximately 4 seconds. Display will
change from time-of-day, show "ON", and then return to time-of-day.
Electronic oven control is equipped with a self diagnostic system. Self diagnostic system
alerts you if there is an error or problem in the control. If the range control sounds a series
of short, rapid beeps for over 16 seconds and display shows a F-code, record the F-code
shown. Some F-codes can be cleared by disconnecting power to the range. If the code
continues to reoccur call an authorized servicer. Disconnect electrical supply to range and
contact an authorized servicer.
F2--High Oven Temperature
F3--Temperature Sensor Malfunction
F4--Temperature Sensor Malfunction
14