Advertisement
Traditional Sonar
3. Position the transducer so its face is
pointing straight down when the trolling
motor is in the water.
Adjustable strap
4. Tighten the adjustable strap securely
to the trolling motor. Make sure there is
enough slack in the transducer cable for
the trolling mount to turn freely.
0.TWEETY INSTALL_SONAR_DSI.indd 8
Connecting the unit to power
1. Connect the black wire to a ground.
2. Attach a 3 Amp fuse (not included) to
Plastic ties (not
included)
3. Connect the Power cable to the Power
Transducer
cable
8
the end of the power wire and then con-
nect the fuse to the positive (+) terminal
on the battery.
port on the back of the display unit.
NOTE: Use 18 gauge wire to extend the
power or ground wires.
9/14/2011 11:55:32 PM
Advertisement
