Advertisement
6. When
finished,
transducer should be parallel with the
hull with a minimum amount of epoxy
between the hull and transducer.
Trolling motor Skimmer and
Pod Installation
The TMB-S trolling motor bracket (Part No. 51-45) is
an optional accessory and is available through LEI
Extras at www.lei-extras.com. The TMB-S bracket
is used to attach a one-piece bracket skimmer
transducer to a trolling motor. The Pod transducer
does not need a TMB-S trolling motor bracket to be
installed on a trolling motor. It only needs a hose
clamp (adjustable strap).
transducer is curved to fit
0.TWEETY INSTALL_SONAR_DSI.indd 7
the
face
of
The top of the Pod
the contour of the trolling
motor, so you do not
need a TMB-S mounting
bracket.
the
Installing transducer on trolling motor:
1. Attach the skimmer transducer to the
bracket as shown in the diagram.
Bolt
2. Slide the adjustable strap (hose clamp)
through the plastic bracket on the
skimmer transducer or through the Pod
transducer slots and then slip the strap
around the trolling motor.
7
Traditional Sonar
Internal tooth
washer
Plastic bracket
Lock
nut
Flat washer
Position the transducer
to so its face is pointing
straight down when the
trolling motor is in the
water.
9/14/2011 11:55:32 PM
Advertisement
