Download Print this page

Ce Declaration Of Conformity; Fcc Notice - Linn LINTO Owner's Manual

Direct coupled precision phono preamplifier
Hide thumbs Also See for LINTO:

Advertisement

CE Declaration of Conformity

Linn Products Ltd declare that this product is in conformance with the Low Voltage Directive 73/23/EEC and
Electromagnetic Compatibility 89/336/EEC as amended by 92/31/EEC and 93/68/EEC. The conformity of the designated
product with the provisions of Directive number 73/23/EEC (LVD) is proved by full compliance with the following stan-
dards:
S S t t a a n n d d a a r r d d n n u u m m b b e e r r
EN60065
12
The conformity of the designated product with the provisions of Directive number 89/336/EEC (EMC) is proved by full
compliance with the following standards:
S S t t a a n n d d a a r r d d n n u u m m b b e e r r
EN55013
EN55013
EN55020

FCC notice

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
D D a a t t e e o o f f i i s s s s u u e e
1998
D D a a t t e e o o f f i i s s s s u u e e
2001
2001
2002
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
T T e e s s t t t t y y p p e e
General requirements
Marking
Hazardous radiation
Heating under normal conditions
Shock hazards under normal operating conditions
Insulation requirements
Fault conditions
Mechanical strength
Parts connected to the mains supply
Components
Terminal devices
External flexible cords
Electrical connections and mechanical fixings
Protection against electric shock
Stability and mechanical hazards
Resistance to fire
T T e e s s t t t t y y p p e e
Conducted emissions
Absorbed emissions
Immunity

Advertisement

loading