LG N2311AZ Owner's Manual page 5

button
MENU
VOLUME (Only PCoIP mode) Adjust the volume of the Monitor set.(See p.21)
AUTO
INPUT
EXIT
(Power Button)
Activates the main menu.
osD lock/Unlock Locks/unlocks the OSD screen.
functions y To lock the OSD screen, press and hold the MENU button
y To unlock the OSD screen, press and hold the MENU
To adjust the monitor settings, press the AUTO button on the MONITOR SETUP OSD
menu (only supported for analog signal).
For optimal screen display, use the following resolution.
optimal Resolution 1920 x 1080
Allows selection of the input signal.
y If you connect the monitor to a computer using a D-SUB cable, select either the PCoIP
or D-SUB input signal.
y The initial input signal is D-SUB.
Exits the OSD menu.
y D-SUB Input: Power On/Off
y PCoIP Input
Monitor Off: Press the power button once then the monitor will be turned off after 5
seconds.
PCoIP Off: Press the power button twice then the monitor and PColP connection will
be disabled.
PCoIP On: Press the power button.
Remote PC Power Control: Press the power button for at least five seconds to turn
* Remote PC Power Control only works on the host PC where PCoIP host card is
installed and requires separate setup.
Power Indicator When the monitor is in operating mode, the power indicator
will turn Red (on mode).
When the monitor is in power saving mode, the power indica-
tor will blink Red.
assEMblInG anD PREPaRInG
Description
for several seconds. The "OSD LOCKED" message will be
displayed and the screen will be locked.
button again for several seconds. The "OSD UNLOCKED"
message will be displayed and the screen will be unlocked.
the PC on/off.
5