Cloning Connections/Learning Setup - LG Zenith HCS5610 Installation And Operating Manual

Cloning Connections/Learning Setup

Connections for the LT2002 Clone Programmer to Learn the TV/STB Master TV Setup.
¤
QuickSet II Programmer
LT2002
*Notes: It is assumed that the TV/STB is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an
Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone
Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer LED is blinking
the required heart beat pattern, see above and next page.
*Notes: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the
clone is operating may disrupt the master setup transfer or copying etc.
Before you begin cloning...
• The Master TV/STB should be connected to a good, stable sig-
nal from an over-the-air antenna or cable service Analog chan-
nel and connected to power. (See above.)
• Teaching and Learning is only possible between identical model
devices. (However, the LT2002 Clone programmer can store up
to 3 different 'master' setups.)
WARNING: Copying a blank or incorrect memory into a TV, STB or
other device will cause the TV, STB or other device to operate
erratically or become inoperable.
• Use an Installer's remote to operate Learning and Teaching
menus.
• Make sure that the batteries in the Clone programmer are fresh.
• If batteries are removed, the Clone Clock time will be lost.
• Decide if you want to set the time from the Clone programmer
TV which has the clock set to the current time.
P A G E 5 0
3.5mm Stereo Plug
with IR Receiver
Ferrite Core
(TDK, ZCAT
2035-0930)
RJP
INTERFACE
RF Coaxial Wire
(75ohm)
DVI
AUDIO IN AUDIO OUT SERVICE
REMOTE
IN
1 2
AUX DIGITAL DIGITAL DIGITAL AUDIO DISPLAY
CONTROL VIDEO IN VIDEO OUT OUT (OPTICAL)
CONTROL
Antenna
Wall Jack
• Setting the time and transferring it to the Clone or other
device is a separate procedure.
• Follow the connection diagram above to connect the Clone to
a Master TV/STB display panel. After learning is
complete, to another identical TV/STB display panel to "teach"
it the master setup.
• After the TV/STB setup has been copied to another
identical TV/STB, that identical unit with the copied setup,
needs to be disconnected from power for about 15 seconds to
activate the newly-copied setup.
• See the Clone Troubleshooting section to resolve problems.
Turn to the next page to continue Cloning Setup.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
AC OUT 8A AC IN 120V~60Hz
AC Power
Cord