Advertisement
Securing Baby
Restraint Belts
• Place your child in the product. Position the restraint pad between
your child's legs.
• Fasten both restraint belts to the buckles on each side of the
restraint pad. Make sure you hear a "click" on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
Anchored End
Free End
TIGHTEN
To tighten the belts: Feed the anchored end of the restraint up
through the buckle to form a loop
restraint
.
To loosen the belts: Feed the free end of the restraint up through
the buckle to form a loop
. Enlarge the loop by pulling on the end
of the loop toward the buckle. Pull the anchored end of the restraint
to shorten the free end of the belt
Please Note: After adjusting the restraint system to fit your child, make
sure you pull on it to be sure it is securely fastened.
Restraint Pad
Anchored End
Free End
LOOSEN
. Pull the free end of the
.
Starting Gliding Motion
Power/Speed Switch
• Make sure your child is properly secured in the seat.
• Slide the power/speed switch to slow
Hint:. In most cases, the slow setting works best for a smaller child,
while the fast setting works best for a larger child. If gliding stops
while using the slow setting, try the fast setting. Give the seat a light
push to start the gliding motion again.
• Be sure to turn this product off when not in use. Slide the power/
speed switch to the off setting
• For best performance, make sure this product is used on a
completely level surface.
Note: If gliding motion is slow in one direction (and you hear a winding
or grinding noise), you may be using this product on an inclined surface.
Use this product only on a completely level surface.
7
or fast
.
.
Advertisement
