Page 3
Battery Installation Hint: We recommend using alkaline batteries for longer battery life. 1,5V x 4 “D” (LR20) • Loosen the screws in the battery compartment door and remove the battery compartment door. • Insert four “D” (LR20) alkaline batteries into the battery compartment. •...
Page 4
Seatback Tube Wide Slot Footrest Tube • Position the footrest tube so that it curves down. • Fit the ends of the footrest tube into the wide slots in the hubs. • Position the seat back tube so that it curves down. •...
Page 5
• Fit the lower pocket on the pad around the footrest tube. Fasten the straps underneath the footrest tube to secure the lower portion of the pad. PUSH PUSH • Push down on the pad to be sure it is assembled properly. If the pad falls through the frame, you have not assembled it properly.
Page 6
WARNING To prevent serious injury or death from falls and being strangled in the restraint system: • Fall Hazard - It is dangerous to use this product on an elevated surface, since child’s movement may cause the product to slide or tip over. Use only on a floor. •...
Page 7
Securing Baby Restraint Belts • Place your child in the product. Position the restraint pad between your child’s legs. • Fasten both restraint belts to the buckles on each side of the restraint pad. Make sure you hear a “click” on both sides. •...
Page 8
Music • Choose the style of music for baby. Slide the music switch to: Soothing Playful • Slide the volume switch to for low volume; Note: Low battery power may cause this product to operate erratically (no movement/no sounds) and the product may not turn off. If this should happen, remove and discard all batteries and replace with four, new “D”...
Need help?
Do you have a question about the J6982 and is the answer not in the manual?
Questions and answers