Advertisement
INSTALLATION DRAWINGS
(Pages 2, 3 & 4)
I
IMPORTANT
PLEASE KEEP FOR THE USE OF THE-LOCAL ELECTRICAL INSPECTOR.
o_
CLEARANCE BETWEEN ,M]JACENT
COMBUSTIBLE COI¢STRUCTIOI_ AriD
TH£ BACK AND SIDe'S OF" THE RANGE
BELOW ,HE COOKING SURFACE.
_ql# 92_f>'l ts
FIGURE 1
NOTE: Figure may not be representative of actual unit.
The 30 inches (76.2 cm) minimum clearance between the
installing a range hood that projects horizontally a
top of the cooking surface and the bottom of an
minimum of 5 inches (13 cm) beyond the bottom of the
unprotected wood or metal cabinet can be reduced to 24
cabinets.
inches (61 cm) minimum when bottom of wood or metal
cabinet is protected by not less than 1/4-inch (6.4 ram)
FIGURE 1
thick flame-retardant millboard covered with not less than
1 ... COMBUSTIBLE BACK WALL.
No. 28 MSG sheet steel, 0.015-inch (0.381 mm) thick
2 ... COMBUSTIBLE SIDE WALL.
stainless steel, 0.024-inch (0.610 ram) thick aluminum, or
3 ... COMBUSTIBLE WALL CABINET.
0.020-inch (0.508 mm) thick copper.
DIMENSION "A" IS TO BE A MINIMUM OF 3 iNCHES (7.5
CM).
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located
A SLIDE-IN RANGE, IF EQUIPPED WITH OPTIONAL
above the surface units should be avoided. If cabinet
8ACKGUARD KIT, MAY BE INSTALLED ZERO INCHES
storage is to be provided, the risk can be reduced by
FROM COMBUSTIBLE WALL 1 (SEE FIGURE 1).
-2-
Advertisement
