Fisher-Price MX3 73535 Owner's Manual & Assembly Instructions page 8

5
1 / " Bolt - 2
9
16
BOTH SHOWN ACTUAL SIZE
• Lift a handlebar to align the hole in the handlebar with
the hole in the front fork.
• Insert a 1 9 / " screw through the outer edge of the
16
front fork, handlebar and then out the inner edge of
the front fork.
• Attach a 7 / " lock nut (rounded edge outward) to the
16
end of the screw and hand-tighten it.
Assembly
Rounded Edge
7 / " Lock Nut - 2
16
8
6
Allen Wrench
• While holding the lock nut with an adjustable wrench
(or a 7 / " wrench), tighten the bolt with the Allen wrench.
16
Do not over-tighten.
• Check to be sure the handlebar is securely attached.
Lift it and push it from side to side. It should not move.
If it does move, tighten the bolt a few more turns with
the Allen wrench.
• Repeat steps 5 and 6 to fasten the other handlebar to
the front fork with a 1 /
9
7
Power Wires
Cut off
Excess
Plastic Tie
• Wrap the plastic tie around the brake cables, power
wires and the handlebar.
• Insert the flat end of the plastic tie into the opening
in the square end of the plastic tie. Pull the flat end of
the plastic tie with pliers to be sure it is tight around
the handlebar.
• Using safety scissors, cut off the excess plastic tie.
Throw the excess plastic tie away.
Adjustable Wrench
" bolt and / " lock nut.
7
16 16
Handlebar
Brake Cables