Roland BK-5 Owner's Manual page 89

Parameter Setting
To Beat 1~[number of
beats per bar]
To CPT 0~119
Resolution 1/4, 1/8, 1/8T,
1/16, 1/16T, 1/
32, 1/32T, 1/64
Strength 0%~100%
From Note 0 C-~127 G9
To Note 0 C-~127 G9
Press the [WRITE] button (its indicator flashes) to
confirm your settings and edit the data.
Explanation
Specifies the beat posi-
tion. The number of
selectable beats
depends on the
selected time signa-
ture.
Refers to the last clock
that should be affected
by the edit operation.
Change this setting
only if your edit opera-
tion should not end
exactly on the selected
beat.
This parameter sets the
resolution of the
Quantize function. Be
sure to always select
the value of the short-
est note you recorded.
Otherwise, your part
no longer sounds the
way you played it,
because shorter notes
are shifted to the
wrong positions.
Use this parameter to
specify how precise the
timing correction
should be. "0%" means
that the selected "Res-
olution" value is not
applied ("0% correc-
tion"), while "100%"
means that all notes
are shifted to the
mathematically correct
positions.
This parameter allows
you to set the note (or
lower limit of the note
range) to be modified
within the specified
"From/To" time range.
This parameter allows
you to set the upper
limit of the note range
to be modified within
the specified "From/To"
time range.
Backing Keyboard BK-5
Rhythm Composer (programming your own rhythms)
Erase
"Erase" allows you to selectively delete data either
within a specified range of measures, beats or clocks
or from the entire track(s). When "Data Type" is set to
"All", "Erase" substitutes the required number of rests
for the data you delete, so that you end up with the
equivalent number of blank measures. If you also
want to eliminate the measures themselves, use
"Delete" (see below).
Parameter Setting
Track ADrums~Acc6,
ALL
Mode Major, Minor,
7th
Division Intro 1~4,
Main 1~4, Fill
Dwn 1~3, Fill
Up 1~3, End
1~4
From Bar 1~[last mea-
sure of the
track or pat-
tern]
From Beat 1~[number of
beats per bar]
From CPT 0~119
r
Explanation
Allows you to select
the track you wish to
edit. You can also
select "ALL" here, in
which case the opera-
tion applies to all
tracks.
Allows you to select
the Mode to be edited.
Use this parameter to
select the Division you
want to edit.
Refers to the first mea-
sure to be edited. By
default, the "From"
value is set to the
beginning of the
selected track(s).
Specifies the beat posi-
tion. The number of
selectable beats
depends on the
selected time signa-
ture.
Refers to the starting
CPT position. "CPT" is
short for "Clock Pulse
Time", the smallest unit
used by the BK-5.
(There are 120 CPTs to
every beat of a 4/4
bar.) Change this set-
ting only if your edit
operation should start
after the selected beat.
89