Setting The Alarm Clock - Roberts Stream 105 Manual

Setting the alarm clock

Your radio has two separate alarms which can be set to wake you to either
the radio or a buzzer alarm. In the event of a power interruption your radio
has a built in memory that will retain your alarm settings.
Ensure that the time is set correctly before setting the alarms. Alarms
cannot be used when running on batteries as the clock is reset from the
internet and does not run in battery mode.
1. With your radio switched on, press and hold the Menu button to access
the menu for the current mode. Rotate the Tuning/Select control until
'Main menu' is highlighted on the display. Press the control to enter
the 'Main menu'.
2. Rotate the Tuning/Select control until 'Alarms' is selected on the
display. Press the control to see the current alarm settings. If no change
is required, press the Menu/Back button to exit.
3. Rotate the Tuning/Select control until the desired alarm (1 or 2) is
highlighted on the display. Press the control to enter alarm setup.
4. Rotate the Tuning/Select control until 'Time' is highlighted on the
display. Press the control to adjust the alarm time.
5. Rotate the Tuning/Select control to choose the alarm hour. Press the
control to confi rm the setting.
6. Rotate the Tuning/Select control to choose the alarm minute. Press
the control to confi rm the setting. The display will then return to the
alarm setting menu.
If the radio has been set to use a 12 hour clock format, there will also
be an option here for setting AM or PM for the alarm time.
53
1,2
1-6