One-Touch Setting; Production Support Function - JUKI CP-180 Instruction Manual

8. ONE-TOUCH SETTING

A part of functon settng tems can be easly changed n the normal sewng state.
WARNING :
For the setting of functions other than those covered in this part, refer to "Instruction manual for the
SC-920".
* Wper functon (
: Wper does not operate after thread trmmng
: Wper operates after thread trmmng

9. PRODUCTION SUPPORT FUNCTION

The producton support functon conssts of two dfferent functons (fve dfferent modes) such as the
producton volume management functon, operaton measurng functon. Each of them has ts own producton
support effect. Select the approprate functon (mode) as requred.
< Production volume management function >
• Target No. of pcs. dsplay mode [F00]
• Target/actual No. of pcs dfference dsplay mode [F200]
The target number of peces, actual number of peces and the dfference between the target and actual
number of peces along wth the operaton tme are dsplayed to notfy the operators of a delay and advance
in real time. Sewing machine operators are allowed to engage sewing while constantly checking his/her
work pace. This helps raise target awareness, thereby increasing productivity. In addition, a delay in work
can be found at an early stage to enable early detecton of problems and early mplementaton of correctve
measures.
< Operation measuring function >
• Sewng machne avalablty rate dsplay mode [F300]
• Ptch tme dsplay mode [F400]
• Average number of revolutons dsplay mode [F500]
Sewng machne avalablty status s automatcally measured and dsplayed on the control panel. The data
obtained can be used as basic data to perform process analyses, line arrangement and equipment efficiency
checkup.
1
)
< One-touch setting procedure >
) Keep swtch 1 held pressed one second to en-
ter the functon settng mode.
2) The set value can be changed by usng swtch 2 .
3) To return to the normal sewng state, press
swtch .
1
2 The setting is confirmed by pressing
switch 1 .
- 9 -