InFocus IN1124 User Manual page 40

3.
Remove the two screws
from the lamp module (A).
4.
Lift the module handle up
(B).
5.
Pull firmly on the module
handle to remove the lamp
module.
6. Reverse steps 1 to 5 to
install the new lamp
module.
While installing, align the
lamp module with the
connector and ensure it is
level to avoid damage.
Note:
The lamp module must sit
securely in place and the
lamp connector must be
connected properly before
tightening the screws.
Turn on the projector and reset the lamp after the lamp module is replaced.
7.
Lamp Reset:
Press Menu → Select Installation II / Advanced → Select Lamp Hour Reset → Press
the ► or buttons → Press ▼▲◄► buttons to reset the lamp hour.
Press the MENU button to get back to Installation II.
IN1124/IN1126 – User's Manual
– 33 –