Maintenance And Security; Replacing The Projection Lamp - InFocus IN1124 User Manual

User's Manual

Replacing the Projection Lamp

Be sure to use the InFocus lamp module designed for this projector. You can order new lamps from
www.infocusstore.com (in select areas), your retailer or your dealer. Only genuine InFocus lamps are
tested for use in this projector. Use of non InFocus lamps may cause electrical shock and fire, and may
void the projector warranty. InFocus is not liable for the performance, safety or certification of any other
lamps.
Warning:
• The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it
may rupture with a popping sound if jolted, scratched, or handled while hot. The risk of lamp
failure or rupture also increases as the lamp age increases.
• Do not touch or block the projector lens with any objects as this can damage the projector
lens. Scratches, gouges and other lens damage are not covered by the product warranty.
• Unplug the power cord before replacing the lamp.
• Do not drop the lamp module. The glass may shatter and cause injury.
• Do not touch the glass surface of the lamp module. Fingerprints can obscure projection
sharpness and may cause the glass to shatter.
• Be extremely careful when removing the lamp housing. In the unlikely event that the lamp
ruptures, small glass fragments may be generated. The lamp module is designed to contain
most of these fragments, but use caution when removing it.
• Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning mate-
rials. Wash hands after lamp replacement.
When replacing the lamp while the projector is ceiling-mounted, wear protective eye-
•
wear to prevent eye injury.
Hg – Lamp contains mercury. Manage in accordance with local disposal laws. See
•
www.lamprecycle.org.
• Be sure to turn off and unplug the projector at least 60 minutes before replacing the lamp.
Failure to do so could result in a severe burn.
1.
Wait 60 minutes for the
lamp to cool before at-
tempting to replace lamp.
Then loosen the two cap-
tive screws on the lamp
compartment cover (A).
2.
Remove the lamp com-
partment cover (B).
M
AINTENANCE AND
– 32 –
S
ECURITY