HP Guardian User Manual page 50

Getting Started With TACL
1. Recall the command with the FC command.
The TACL program displays the first line of the command:
29> FC [R
30> [ RUN $APPS.EMPLOYEE.LISTPGM / IN $DISK88.EMPLOYEE.NAMES,
30..
2. If you don't have any changes for the first line, press Return.
The TACL program displays the second line with the same line number.
3. Change the spooler location to #HOLD just as you would change a single-line
command, and press Return.
30> OUT $S.#LAZR, NOWAIT / ]
30.. HOLD
4. The TACL program again displays each line for you to confirm your change.
5. Make additional changes, as needed. Press Return after each line.
After the last line, the TACL program executes the changed command.
Guardian User's Guide —425266-001
2- 20
Changing or Correcting a Previous Command