HP NonStop SSL Reference Manual page 84

The following steps have been performed for the above setup:
1. An Expand Multi-Line path was created on each system.
•
2 CPUs were selected for the LH primary and backup.
•
To distribute SSL CPU load over the remaining CPUs, 6 lines were created for the path.
•
A unique port number was selected for each line (SRCIPPORT and DESTIPPORT can be identical).
•
DESTIPADDR of all lines was set to the loopback address (127.0.0.1).
2. Six HP NonStop SSL EXPANDS persistent processes were created on both systems.
•
A different CPU was selected for each SSL process.
•
The SSL tunnel was associated to the line using the same SRCIPPORT and DESTIPPORT parameters as in
the line configuration.
•
The DESTIPADDR parameter of the HP NonStop SSL EXPANDS processes was set to the remote
system's IP address.
84 • Configuration
HP NonStop SSL Reference Manual