HP NonStop SSL Reference Manual page 20

$FTPC0|29Jul12 16:38:40.45|30|-- FTPC setup completed, starting to listen... --
To create a secure FTP connection to a remote FTP-TLS server
1. Issue the following command at the command prompt:
> FTP localhost 8021
where
•
the first parameter denotes the local loopback address
•
the second parameter specifies the port number the HP NonStop SSL FTPC proxy is listening on
The HP NonStop SSL FTP client mode welcome message will now be displayed. You will be prompted for
user-id and password:
FTP Client - T9552H02 - (10JUL2009) - COPYRIGHT TANDEM COMPUTERS INCORPORATED 20
09
Connecting to 127.0.0.1.........Established.
220 HP NonStop SSL version T0910H01_19JUL2010 running in encrypting FTP client m
ode
Name (127.0.0.1:user):
2. At the user id prompt, enter the following data:
<user id>@<remote address>[:<port>]
where
•
<user id> is the user name valid to login to the remote secure FTP server.
•
<remote address> is the IP address or DNS name of the remote system where the secure FTP server is
running on.
Note: if the remote address is an IPv6 address it has to be surrounded by square brackets. (E.g.
john@[fe80:aa::bb42]:12345)
•
<port> is the port number the remote FTP server is listening on. If omitted, 21 is used as a default.
The connection should now be established, allowing you to list directories and transfer files securely:
Name (127.0.0.1:user): tb@172.24.91.233
331- original FTP server Welcome follows
331- 220 NOTEBOOK_TB X2 WS_FTP Server 3.1.4 (3995038631)
331- original FTP server reply to USER command follows
331 Password required
Password:*****
230 user logged in
ftp> dir
200 command successful
150 Opening ASCII data connection for directory listing
drwxr-x--- 2 tb
drwxr-x--- 2 tb
-rwxr-x--- 1 tb
-rwxr-x--- 1 tb
-rwxr-x--- 1 tb
-rwxr-x--- 1 tb
226 transfer complete
496 bytes received in
ftp>
Note: Starting HP NonStop SSL version AAE, an FTPC default host and FTPC default port can be specified by using
the parameters TARGETHOST and TARGETPORT. The respective parameter values will be taken into account if the
user does not specify the corresponding value - or - if HP NonStop SSL was configured to always use the values of
TARGETHOST respectively TARGETPORT due to the additional parameter TARGETHOSTFORCE or
TARGETPORTFORCE. Please see corresponding parameter description for details.
20 • Installation
System 0 Oct
System 0 Oct
System 161 Dec 12 12:17 l1
System 161 Dec 12 12:17 l2
System 161 Dec 12 12:17 l3
System 1447718 Dec 12 12:20 testfile
0.07 seconds ( 6.92 Kbytes/s)
1 19:17 .
1 19:17 ..
HP NonStop SSL Reference Manual