HP NonStop SSL Reference Manual page 122

This warning indicates an incorrect sequence in the communication with the HP NonStop SSL process. It e.g
happens when SSLCOM is run with a certain HP NonStop SSL process and the HP NonStop SSL process is then
restarted with the same process name without restarting SSLCOM. In this case, any command in SSLCOM will
result in an empty response. To resolve the error condition, restart SSLCOM.
AWAITIOX file <filename> (filenum <file_descriptor>) completed with error <error number>
(<errorstring>)
This message indicates an error on the file <filename>. The <error number> and <errorstring> will give the error
reason. Watch for the messages that come along with this one for the context of the error.
CEventDispatcher::Dispatch - unexpected event
This message probably indicates a programming error. Please contact HP support.
received invalid expand tunnel message header
This message indicates a problem on Expand level. Please contact HP support if you see this message.
could not send complete Expand UDP packet
This warning occurs when the HP NonStop SSL process failed to send out an Expand UDP packet. Please watch for
messages that come along with this one and check your Expand line status.
ExpandProxy failed to set up SSL Tunnel listen on <srcipaddr>:<port>, errno=<error number>
<errorstring>
This message indicates that an error occurred when trying to set up the SSL Tunnel for EXPANDS mode. See the
<errorstring> for a detailed reason. This can include an error due to passing an invalid SUBNET or SRCIPADDR,
or errors on the TCPIP stack. Please watch for messages that come along with this one to resolve the error condition.
As a result of this message the HP NonStop process will sleep for the value specified in
LISTENRETRYINTERVAL (default 10 sec).
accepting tunnel connection failed, reinitializing
This message indicates that the HP NonStop SSL process is currently in the handshake phase. When the Expand
lines and the HP NonStop SSL processes are set up correctly, this message will occur a few times until the
handshake completed successfully. Otherwise please check your Expand and HP NonStop SSL configuration.
Failed to Connect to client side of proxy: host=<host>, port=<port>
This message indicates a failure when establishing the connection to <host>:<port>. Please watch for messages that
come along with this one for the context of the message.
Could not refresh IP address of host <host> (<error_reason>), will keep existing IP address <ip>
This message occurs when a DNS host entry was specified, e.g. for TARGETHOST but the DNS resolution fails.
HP NonStop SSL will resolve the hostname every time it connects and - to make sure that the DNS entry is valid
initially - during startup. If the DNS resolution fails after startup the last successfully resolved IP address <ip> will
be used.
Could not refresh ipAddress SocketAddress::ipAddress(): <error reason>
This message might indicate a bug, please contact HP support.
random data was not seeded properly
This message might indicate a bug, please contact HP support.
Wildcard is included in trusted fingerprint strings, this is insecure since every peer is trusted! Please
consider using fingerprints (<secure_fingerprint_algorithms>)!;
This message indicates that no fingerprints were set in the TRUST parameter, thus every peer is trusted. Please see
parameter TRUST for details.
122 • Appendix
HP NonStop SSL Reference Manual