Pump Motor; Fan Motor - Hoshizaki AM-100BAE Service Manual

6. PUMP MOTOR

1) Unplug the icemaker or disconnect the power source.
2) Remove the Top Panel, Door and Front Panel.
3) Disconnect the Pump Motor leads behind the Evaporator.
4) Drain the Water Tank by compressing the plastic tabs on the Suction Tube to release the
Joint.
5) Spread the tabs on both sides of the Water Tank and pull it toward you.
6) Carefully remove the plastic housing by releasing the retaining screws.
7) Disconnect the Pump Suction and Discharge Tubings.
8) Release the pump retaining screws to remove the Pump.
9) Install the new motor in the reverse order of the removal procedure.
10) Plug in the icemaker or connect the power source, and check for leaks.
11) Refit the panels in their correct positions.

7. FAN MOTOR

1) Unplug the icemaker or disconnect the power source.
2) Remove the Front Panel.
3) Disconnect the Connector of the Fan Motor.
4) Remove the Fan Motor Bracket and the Fan Motor.
5) Cut the leads of the Fan Motor allowing enough lead length to reconnect using closed end
connectors.
6) Install the new Fan Motor in the reverse order of the removal procedure.
7) Refit the panels in their correct positions.
9) Plug in the icemaker or connect the power source.
51