Parts And Functions - Haier Thermocool HSU-12HQA03 Operation Manual

Parts and Functions

Indoor Unit
Inlet
Inlet
grille
Nano-Aquo
Generator
Outlet
inside
Actual indoop unit may vary from the one shown
in the manual, according to the product purchased.
Display board
Aureole
Display mode the aureole display different
colour when setting different function
HEAT: red
COOL: blue
AUTO: white DRY: cyan
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
4 DRAIN HOSE
INLET
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press
or decrease 1min. If the button is kept pressed,time will
change quickly. After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
Air Purifying
Filter Anion
generator
(inside)
Vertical blade
(adjust left and
right air fl ow)
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
TEMP display
FAN: yellow
: green
Nano-Aquo
will increase
Remote controller
31
1. RESET button
When the remote controller
appears abnormal,use a
sharp pointed article to press
this button to reset the remote
controller controller normal.
2.LIGHT button
Control the lightening and
extinguishing of the indoor
LED display board.
3. TIMER button
4. CLOCK button
5. SLEEP button
6. MODE button
7. HOUR button
8. HEALTH button
The following functions and related displays are not available
Loading of the battery
2
1
3
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
type fluorescent lamp or
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and
Hint:
Remove the batteries in case unit won't be in usage for a long period.
If there are any display after taking-out, just need to press reset key.
2
9. ON/OFF button
10. TIMER ON display
11. FAN SPEED display
19
LOW HI
MED
12. LOCK display
13. SWING display
14. SLEEP display
15. HEALTH display
16. Operation mode display
Operation mode AUTO COOL DRY
28
Remote controller
17.Singal sending display
30
18. POWER/SOFT display
19. Left/right air flow display
20. TEMP display
21. TIMER OFF display
22. TIMER display
23. TEMP button
24. FAN SPEED button
25. HEALTH AIRFLOW button
26. SWING UP/DOWN button
27. SWING LEFT/RIGHT button
28. SET button
29. POWER/SOFT button
30 . LOCK button
If pressed, the other buttons will be
disabled. Press it once again, lock
will be cancelled.
31. CODE
Used to select CODE A or B with a
press, A or B will be displayed on LCD.
Please select A without special
explanation.
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
is in line with the " + "/"-";
wireless telephone is installed in the
reload several minutes later.
AUTO
HEAT FAN
31