Related Manuals for Haier HWD-D1200TXVE
Summary of Contents for Haier HWD-D1200TXVE
- Page 1 USER MANUAL Automatic Drum Washing Machine HWD-D1200TXVE HWD-D1200TXVEME HWD-D1000TXVE HWD-D1000TXVEME...
-
Page 2: Table Of Contents
Table of contents page no. Before use Parts ......................1 Safety instructions ................. 2 - 4 Installation .................... 5 - 6 Functions ....................7 - 8 Using the appliance Programme selection ................. 9 Preparation ....................10 Using your appliance ................ 11 - 12 Other functions .................. -
Page 3: Parts
Parts Top panel Detergent Power button dispenser Selection dial Display Door Door handle Porthole Power cable Packing bolts (3) Earthing terminal Back plate screws (3) Hose clip Drain hose Back plate This diagram may vary slightly with the layout of the washing machine you have just purchased due to technical improvements. -
Page 4: Safety Instructions
Safety instructions Using your appliance will be simple, but please make sure read the following to get the best out of it and to ensure your own safety. BEFORE sWITChING ThE applIaNCE ON FOR ThE FIRsT TIME: ✓ Ensure you connect the appliance directly to a domestic mains water supply. - Page 5 DURING DaIlY UsE OF ThE applIaNCE ✓ Unplug the appliance before carrying out any maintenance or repair. ✓ Hold the plug and not the electric cable when unplugging the washing machine. ✓ Keep the door slightly open when not in use to prevent formation of odours.
- Page 6 Safety instructions Electrical connection (UK ONlY) For your safety please read the following information Warning: This appliance must be earthed. The appliance must be connected to a 220 volt 240 cycle AC supply by means of a three pin socket, suitably earthed and should be protected by a 13 amp fuse.
-
Page 7: Installation
Installation Caution: protective gloves should be warn • Remove all the packing materials (including the foam base) to prevent vibration during use, as show in Fig. 1. On opening, water drops may be visible on the appliance. This is a normal phenomenon. - Page 8 The power supply socket and the plug of the washing machine should be compatible. If they are not compatible, refer to a washing machine technician or Haier designated service engineer for power cable replacement. • The washing machine should be earthed and in compliance with applicable law.
-
Page 9: Functions
Con t r ol pa n el Wash Wash Rinse Spin Quickwash Rinse Spin Wool Synthetics Time Delay Extra rinse Start/Pause Iron Cotton&Linen Prewash Air wash Power button G. Start/Pause button Programme selection dial button C . Detergent distribution drawer Dry button D. -
Page 10: Functions
Functions G. start/pause button When the washing machine is connected to the power socket and a programme is selected, touch this button to start operation. Touch this button again during operation to pause the programme. The display screen will flash and the machine will be paused. Press the button again and the programme will continue. -
Page 11: Programme Selection
Programme selection guide Detergent setting Default Default setting laundry setting Comp 1 Comp 2 Comp 3 Prewash * 30°C 40°C 1200rpm ★ ★ Heavy-soiling 50°C 60°C 90°C 40°C Cotton & Linen * 30°C 40°C 1200rpm ★ Cotton fabric 50°C 60°C 90°C 40°C Synthetics * 30°C 40°C... -
Page 12: Preparation
Preparing for a cycle Detergent selection Only special low foam detergent should be used in automatic drum washing machines. For blended or wool fabrics, special detergent should be used. Dry cleaning solvent should not be used. Caution: do not use too much detergent. laundry treatment •... -
Page 13: Using Your Appliance
Programme times Program Default time (minute) Prewash Cotton & Linen Synthetic Wool QuickWash Wash Rinse Spin Iron Air wash Using your appliance 1. loading Open the door, put in the laundry piece by piece and then tightly close the door. Notes: 1) Before the first run of the appliance it is advisable to run the machine empty on a quick wash with no detergent to clean through the system. - Page 14 Using your appliance 3. selecting washing programme To get the best wash, an appropriate washing programme should be selected according to the type of laundry. 4. Washing temperature settings Set the washing temperature as required, otherwise set at position * when a cold wash is acceptable.
-
Page 15: Other Functions
Other functions 1. Control panel lock function: To prevent children from accidentally changing the settings, the control panel can be locked by pressing the “Temperature” and “Delay” buttons at the same time. After the panel is locked, the sign “LOCK” and the remaining wash time will be displayed on the LED alternately. -
Page 16: Maintenance
Maintenance 1. Turn off the water tap and pull out electricity plug after each wash. Open the porthole to prevent formation of moisture and odours. If the washing machine is left idle for a long period, drain the water in the machine and replace the drain hose. - Page 17 Maintenance 5. To prevent blockage to the water supply by ingress of foreign substances, clean the water inlet and inlet filter regularly. 6. If the machine is to be moved to a distant place, replace the vibration absorbing locks (packing screws, rubber gaskets) removed before installation to prevent damage as shown below.
-
Page 18: Trouble Shooting
Trouble shooting In the unlikely event of difficulties with your appliance please follow the trouble shooting guide below. If the problem persists, contact an approved service engineer. If an error code is displayed, please refer to the error code guide below. problem possible cause how to correct the problem... -
Page 19: Technical Specifications
Tech n ica l speci- c a t ion M odel / Item HWD-D1000TXVE/M E HWD-D1200TXVE/M E Power Source 220-240 V/ 50Hz 220-240 V/ 50Hz Working C urrent (M ax) (A) Tap Water Pressure 0.03 0.03 (M Pa) Washing Power (W) - Page 20 We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.