Advertisement
(SUPPLEMENT TO SECTION 5 OF THE ACCOMPANYING GCL™ INSTALLATION MANUAL)
Line Voltage Wiring Fig. 1
WARNING
•
NOT
DO
apply power to operator until instructed to do so.
• Overhead Door Corporation recommends that line voltage wiring
be performed by a qualified electrician.
• Be sure that electrical power has been disconnected from the
input power wires being connected to the operator prior to
handling these wires. An appropriate lock-out /tag-out procedure
is recommended.
• Line voltage wiring must meet all local building codes.
Make
sure operator voltage, phase and frequency nameplate
•
ratings are identical to the job site line voltage ratings.
• Input power wiring must be properly sized for the operators
amperage rating located on the nameplate.
• To reduce the risk of electric shock, make sure the chassis of this
unit is properly grounded.
1) Remove LINE VOLTAGE INPUT PLUG and install proper
fittings and 1/2"conduit.
2) Route proper LINE VOLTAGE wires into operator.
3) Locate LINE INPUT terminals on circuit board. Using
correct connectors, attach wires to LINE INPUTS, and GROUND
terminal.
• Keep low voltage and line voltage wires separate.
• Route all line voltage wires as shown.
• Plug all unused conduit holes.
NOTE: LIQUID-TIGHT CONDUIT AND FITTINGS ARE NOT PROVIDED
GCL
High Voltage Wiring
www.geniecompany.com
Figure 1
LINE
208/240V 480/575V
GROUND
Optional
Accessory
Modules
HIGH
VOLTAGE
INPUT
PLUGS
Optional
(Right
Additional
& Left)
Transformer
ROUTE HIGH VOLTAGE WIRING
IN THE SHADED AREA AS SHOWN
LINE
GROUND
HIGH
VOLTAGE
INPUT
PLUGS
Optional
(Right
Additional
Transformer
& Left)
ROUTE HIGH VOLTAGE WIRING
IN THE SHADED AREA AS SHOWN
8-12
LINE INPUT
TERMINALS
Three Phase
LINE IN
POWER CONNECTIONS
L1
L2
L3
LINE 1 LINE 2 LINE 3
GND
LINE INPUT
TERMINALS
Single Phase
POWER CONNECTIONS
L1/L1
N/L2
LINE
115V
NEUTRAL
(HOT)
208V
LINE 1 LINE 2
230V
GND
1
Advertisement
