Razor E500S Owner's Manual page 9

TROUBLESHOOTING GUIDE
Problem
Sometimes the scooter
doesn't run, but other
times it does
Charger gets warm
during use
Scooter does not stop
when applying the brake
Scooter makes loud
noises or grinding
sounds
Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or
call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Possible Cause
Loose wires or connectors
Motor or electrical switch damage
Normal response to charger use
Brake not adjusted properly
Chain is too dry
Brake rotor is dragging on brake pads
Solution
Check all wires around the motors and all connectors to make sure
they are tight.
Contact your local Razor authorized service center for diagnosis and
repair.
No action required. This is normal for some chargers and is no cause
for concern. If your charger does not get warm during use, it does not
mean that it is not working properly.
Refer to adjusting the brake instructions on page 4 .
Apply a lubricant such as 3 in 1
Use your fingers to twist the caliper adjuster in either direction until
rotor is centered between pads.
8
TM TM
or Tri-Flow to the chain.