Promaster RL60 Specification

Led macro ring light

Macro Ring Light

RL60 LED

Thank you for purchasing the PROMASTER

RL60 LED Macro Ring Light.

Please read the following instructions to ensure the best

operation of your light panel.

Installing the Batteries

Remove the battery cover from the back of the light by gently

pressing the battery door and sliding it downwards.

Insert 2 AAA batteries (not included) as shown. Be sure the batteries

are inserted with the correct polarity (+,-) as shown in the battery

compartment. Reinstall the battery cover.

After the batteries are properly installed use the power switch to turn the RL60 on or off.

The RL60 Macro Ring Light attaches to the front of your camera's lens using PROMASTER

Macro Ring P mounting rings or Cokin

P Series mounting rings. (Mounting rings must be purchased separately.)

Select the Macro Ring P that matches the filter size of the lens that you wish to use.

Rings are available in sizes from 52mm to 77mm.

Macro Ring P

First mount the Macro Ring P to your lens.

After mounting the Macro Ring P to your lens, slide the RL60 LED

Macro Ring Light over the flange of the ring until it locks in place.

To remove, simply reverse the process.

Table of Contents

Do you have a question about the RL60 and is the answer not in the manual?

Page 1: Installing The Batteries
Insert 2 AAA batteries (not included) as shown. Be sure the batteries are inserted with the correct polarity (+,-) as shown in the battery compartment. Reinstall the battery cover. After the batteries are properly installed use the power switch to turn the RL60 on or off. Attaching to your camera ®...
Page 2: Specifications
Using with AC power The RL60 LED Macro Ring Light can also be used with AC power. To power from AC it is best to REMOVED the batteries. Insert the barrel plug from the AC power supply (included) into the power input port on the side of the RL60. The plug the AC power supply into a standard AC outlet.