Double Deck Models - Sunfire SDG-1 Installation And Operation Manual

INSTALLATION Continued

Double Deck Models

A. Position insert in bottom leg opening and tap insert up
into leg until it seats at collar. Attach eight inch (8") legs
to lower oven section. Raise unit or lay on its left side. (as
shown previous page). Place the front legs on the oven
so as to line up with four (4) attaching bolt holes. Secure
leg to oven frame using (4) 1/4 x 20 bolts and washers
provided. Repeat at rear of unit.
B. Remove combustion chamber front of top deck (located
under oven doors). Raise top deck into place and line
up body sides and back of the unit. Position mounting
angle to line up with four attaching holes located in
center of unit. You the installer, must drill two holes in
the main top of the bottom deck to secure the mounting
angles. Secure mounting angle with four (4) metal
screws provided. Fasten the rear of the units of the (2)
units together, with the mounting strips to line up four
attaching holes located in the base of the top deck and
the top of the lower deck.
C. The flue for the Convection Oven consists of three
pieces. A lower flue box and an upper flue box and a
riser which connects the two flue boxes. Attach flue box
over flue opening at the rear of the top unit with screws
provided. Do the same for bottom units. A second angle
bracket, (identical to the one used on the front), attaches
the lower flue box to the back of the upper oven, as
shown. Once complete install the flue riser as shown in
diagram. (Drawing at right is shown with optional direct
connection with down draft diverter see "Venting And Air
Supply").
D. Assemble the stacking pipes provided in the Stacking
Kit as shown. Check leveling of unit four (4) ways (by the
oven rack inside the oven), and hook up gas feed line.
E. Plug the cord set of each unit into a 115 Volt power
supply outlet.
F Maintain clearance from combustibles.
CAUTION: Disconnect both unites from electrical supply
before servicing.
Page 8
Front View With Top Combustion Cover Removed
Down Draft
Diverter
Flue Riser
Flue
Boxes
Angle Bracket
Mounting
Brackets
REAR VIEW
Side View
Angle
Mounting
Bracket
Part # 1844030 (03/19/10)