Table of Contents
Advertisement
INTRODUCTION
Please read all sections of this manual. This product must be
installed by professional personnel as specified. Garland/U.S.
Range products are not approved or authorized for home or
residential use, but are intended for commercial applications
only. Garland / U.S. Range will not provide service,
warranty, maintenance or support of any kind other than in
commercial applications.
Like any other fine precision built appliance your oven
should be given regular care and maintenance. Periodic
inspections by your dealer or a qualified service agency are
recommended. We suggest installation, maintenance and
repairs should be performed by your local authorized service
agency listed in your information manual pamphlet, or
you may contact Garland/U.S. Range directly using contact
information listed on the front of this manual. Factory
specified replacement parts must be used to maintain listing.
Use of "Generic" Replacement parts may create a hazard and
will void listing.
INSTALLATION
Clearance
Unit must be installed with no less than one inch
(1", 25mm) clearance from combustible construction at both
sides and six inches, (6", 152mm) at the rear. Installation to
Non-combustible construction is (0") clearance at both sides
and six inches (6", 152mm) from the flue riser at rear. The unit is
suitable for installation on combustible floors.
•
For reduced clearance refer to ANSI Z223 1/NFPA #54.
Location
Each gas appliance shall be located with respect to building
construction and other equipment so as to permit access to
the appliance. Such access and clearance may be necessary
for servicing and cleaning.
NOTE: Adequate clearance must be provided for servicing
and proper operation.
IMPORTANT All gas burners and pilots need sufficient air
to operate and large objects should not be placed in front
of this oven, which would obstruct the airflow through the
front.
Part # 1844030 (03/19/10)
Rating Plate
In the event you have any questions concerning the
installation, use, care or service of this product, write or call
our Product Service Department.
When corresponding with the factory or your local
authorized factory service center regarding service problems
or replacement parts, be sure to refer to the particular unit
by the correct model number (including the prefix and suffix
letters and numbers) and the warranty serial number. The
rating plate located behind the combustion chamber front
cover contains this information.
Objects should not be placed on main top rear of oven while
in use. This could obstruct the venting system of the units
flue products.
For your safety: Keep your appliance area free from
combustibles.
Installation for Ovens Equipped with Casters
A. The installation shall be made with a connector that
complies with the standard for Connectors for Movable
Appliances, ANSI Z21.69-1987 (or latest edition) and a
quick-disconnect device that complies with the Standard
for Quick-Disconnect Devices for use with Gas Fuel, ANSI
Z21.41-1989 (or latest edition).
B. The front casters of the unit are equipped with brakes to
limit the movement of the oven without depending on
the connector and any quick-disconnect device or its
associated piping to limit the appliance movement.
C. The restraint can be attached to the unit near the gas
inlet. If the restraint is disconnected, be sure to reconnect
the restraint after the oven has been returned to its
originally installed position.
Page 5
Hide quick links:
Advertisement
Table of Contents
