10.1 Activating the Alarm Function
You have to configure the settings on the Web interfaces of the DVR / Mobile DVR / NVR or
IP cameras, and then configure the protocol and port settings of the Alarm Server to activate
the alarm function.
• On the Web interface of the DVR:
a. Check the Enable box and enable the Network Alarm function on the Motion, Video
Loss or Alarm / Event settings page.
b. On the Network settings page, click Alarm Server, type the IP address of the local
computer, select a Protocol and enter 1600 in the Port field. Type a 10-digit network
ID for network identification.
Figure 10-3
Note: All devices connected to the PowerVideo Plus have to be set up with a 10-digit
network ID for the Alarm Server to work.
Figure 10-2
42
PowerVideo Plus