Net Dimension; Installation And Accessory Parts - Euromaid DW12S Service Manual

Serial Number: 0120505472 Version: 00.00 Edition: 2007-01
Dishwasher
Model: DW12S BOM: FA05N0E0200

3.Net dimension

4.Installation and Accessory Parts

4.1 Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can
be positioned on the right or the left to facilitate proper installation.
4.2 Leveling the Appliance
Once the appliance is positioned, adjust the feet (screw them in or out) to level the dishwasher. In any case,
the appliance should not be inclined more than 2°. If the appliance is level,it will help ensure proper
performance.
4.3 Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(gas) connector and make sure that it is fastened tightly
in place (see Fig 1).
If the water pipes are new or have not been used for an extended period of time,let the water run to make sure
that the water is clear and free of impurities.If this precaution is not taken,there is a risk that the water inlet can
get blocked and damage the appliance.
4.4 Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the sink, making sure
to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see Fig.2). The
free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water.
Page 3 of 16